Request for Quote

* Required Fields


SynTECH-N No Clean Solder Paste

LEAD TIME: 250 Gram Jar In Stock    |     PRICE : $60.00
Data Sheet PDF

Manufactured by Amtech, the SynTECH-N solder paste was designed for stencil printing. SynTECH will give you long stencil life, wide reflow window, good wetting compatibility and clear residue. Designed for the stencil printing process, one of the most important parts in the printed circuit board assembly process.

  • Low voiding
  • Synthetic materials
  • Stencil life > 10 hours
  • Wide reflow window
  • Excellent wettabilitty compatibility
  • Compatible with enclosed printing heads

Product Description
The NC650 No Clean Solder Paste is a modified rosin based solder paste, which allows a previously unseen level of repeatability and consistency. This solder paste offers an excellent open time, extended abandon time and good soldering activity with pin probable post soldering residues.

  • Pin- Probable Residue
  • ROL0 to ANSI/J-STD-004
  • Enhanced activity for tough to solder printed circuit boards and components
  • Excellent slump resistance
  • High speed stencil printing up to 100mm/sec
  • Excellent tack performance and printer open time
  • Extended “between-print” abandon time

  • Performance
    The performance of solder paste depends in part on the metal content, solder alloy and the solder particle size range. Increasing metal content reduces the tendency to slump and reduces the tack life of the solder paste, while the solder balling performance improves.

    Refrigeration and storage: It is recommended to store the NC650 solder paste at 5-10°C. The solder paste should be removed from cold storage a minimum of 8 hours in the unopened container prior to use. If the solder paste does not reach room temperature, it may stick to the stencil, not deposit onto the SMT pads, de-wet pads during reflow, outgas during reflow, or produce solder balls. Avoid direct sunlight.

    Handling and shelf life: The optimum temperature and humidity are 75°F and 60% or below respectively. Provided SynTECH-N solder paste is stored tightly sealed in the original container at 5-10°C, a minimum shelf life of 6 months can be expected. Air shipment is recommended to minimize the time that containers are exposed to higher temperatures.

    The SynTECH solder paste is currently available for stencil printing down to 16 mil (0.4mm) pitch devices with type 3 powder (-325+500 mesh). Printing at up to 100 mm/sec. can be reliably achieved in production using a metal squeegee blade. This is due to a unique rheology, which ensures that the higher shear rate viscosity is relatively low and the thixotropic index is high enough to ensure excellent definition and slump resistance, while maintaining good roll and drop off behavior. High squeegee pressures are not required, making the SynTECH No Clean solder paste particularly useful for second side printing processes.

    Reflow should be performed at 35-40°C above the liquid temperature of the alloy (depending on the type of ). This temperature should be maintained for 30-45 seconds. Profiles should have less than a 3-minute preheat time above 260°F(130°C) to insure proper wetting of fine pitch leads.

    If cleaning is required, use a semi-aqueous solvent or DI water with a saponifier such as Florida Cirtech RA2000 (saponifier concentration 4-6% @ 120-150°F).

    Health & Safety:
    This product, during handling or use, may be hazardous to health or the environment. Read the Material Safety Data Sheet and warning label before using this product.

    The SynTECH solder paste is also available in: 500gram gram plastic jar. 1Kilogram, 500 gram or 250 gram cartridge for direct application. DEK ProFlow cassettes available upon request.